The timing chain that we’re looking at in this Mazda CX-7 has a total of three mounting points.
Two up top that are approximately four inches in diameter and sit six inches apart, leaving only about a two-inch gap between the pulleys, and then at the bottom of the engine, a small three-inch diameter rotating crank pulley. Because we have these two round pulleys at the top and one at the bottom, we have a guide on either side to hold that tension tight and then a rod that pushes against it to hold this chain in place.
The video we’re looking at shows the top two cams and that two inches between them. Where there should be no slack at all in the chain, we can deviate the chain more than an inch of motion. The factory specification for this chain says if there are more than 23 thousandths of an inch of play in the longest portion of it, it’s due for replacement. It says if there are more than 10 thousandths of an inch of play in the short section, it’s due for replacement. We measured the flexion at over an inch. This chain is stretched one hundred times more than the factory should have allowed.
If you have a Mazda or Ford vehicle that’s timing-chain driven, please give us a call here at Saul’s Automotive. We can check this before it becomes a failure. We can inspect it with the lab-scope camera free of charge and tell you the exact condition of the chain in your vehicle.
Give us a call at 303-919-7769 if you suspect any timing chain problems with your car or truck.
Schedule Your FREE Diagnostic Mazda Auto Repair Upkeep and Repair Appointment
Check Out Our Reviews On Yelp! And Leave A Great One For Us!
Join our conversation on Facebook
Explore Our Exceptional Denver Auto Repair Services
Brake Repair Service Suspension Repair Steering Repair Engine Repair Automotive Air Conditioning and Heating Repair